> I write my own firmware for all of my ESP devices and I can confirm, those definitely are the bulk of the work. I was doing that too for all of my projects.

> I write my own firmware for all of my ESP devices and I can confirm, those definitely are the bulk of the work. I was doing that too for all of my projects. I was developing them as if they were products I could potentially sell. When I accepted that I wasn't ever going to do that, I gave ESPHome a try. > took less than an hour to write since I was able to copy-paste all of that boilerplate from a previous project. It would probably take 5 minutes to configure from scratch ESPHome, less time if you're copying from an existing config. In addition to that, you get automatic logging into Home Assistant and deep integration for free. Using Hypfer's discovery[1] that you could read the raw values from Ikea's Vindriktning using an ESP, I wrote an ESPHome script for an ESP01 that pipes the data into Home Assistant. Now when I'm cooking and the air quality gets too bad my HVAC fan kicks on to clear the air. It took longer to solder everything up than it did to "code". YAML: esphome: name: air-quality-sensor-1 esp8266: board: esp01_1m # Enable logging logger: # Disable logging baud_rate: 0 # Enable Home Assistant API api: ota: password: !secret aqs_ota_password wifi: ssid: !secret wifi_ssid password: !secret wifi_password # Enable fallback hotspot (captive portal) in case wifi connection fails ap: ssid: "Air-Quality-Sensor-1" password: !secret aqs_hotspot_password captive_portal: # Setup Ikea Vindriktning PM2.5 sensor uart: rx_pin: GPIO3 baud_rate: 9600 sensor: - platform: pm1006 pm_2_5: name: "Ikea Vindriktning PM25" filters: - sliding_window_moving_average: window_size: 10 send_every: 10 [1] https://github.com/Hypfer/esp8266-vindriktning-particle-sensor https://github.com/Hypfer/esp8266-vindriktning-particle-sens...