3 ms·
It is true the power usage of a K7 per op will drop if you redesign the core to use 32nm. That's a key detail though- you can't just drop a 130nm design onto a
by sliverstorm 15y ago
It is true the power usage of a K7 per op will drop if you redesign the core to use 32nm. That's a key detail though- you can't just drop a 130nm design onto a 32nm mask.
There are many hitches with this idea though. K7 cores have limited power management capability; modern cores have sophisticated frequency scaling, and shut down sectors that are idle. K7 cores are 32-bit. K7 cores do not support most modern extended instruction sets. 50 active K7 cores on one die will generate way more than 125W, causing cooling problems. In short, there are a lot of issues with dated processors that we don't think about, because we take the advances for granted.
This is not to say your idea does not have merit. If it was I, I would probably first investigate using a Bobcat core. The Bobcat core has low power usage for a x86 core (good for packing a large number of cores on one die), and considering a single Bulldozer 'module' (core) has 200M transistors, the Bobcat probably has ?100M?, allowing you to fit ?20? cores with 2 threads each.
P.S. If you are about to brush off the extended instruction sets bit, consider who a 50-core die would interest most. My guess is the scientific community would be a large part of the target markets, and I believe they make great use of extended instruction sets.