2 ms·
> Could this be used for CPU (or some other truckload-of-pins chip) "reballing"? The datasheet[1] says the minimum gap between conductors is 0.4mm, so based on
by magicalhippo 5y ago
> Could this be used for CPU (or some other truckload-of-pins chip) "reballing"?
The datasheet[1] says the minimum gap between conductors is 0.4mm, so based on that it should work for 0.5/0.65mm BGA.
Also would clearly affect the speed you can run things at due to introducing parasitics. But would certainly be fun to try.
[1]: https://multimedia.3m.com/mws/media/66235O/3m-electrically-conductive-adhesive-transfer-tape-9703.pdf https://multimedia.3m.com/mws/media/66235O/3m-electrically-c...
- teraflop 5y agoGetting the chip lined up accurately enough might be a bit trickier. With soldering, you can normally rely on the solder's surface tension to pull the pads into alignment.