2 ms·
Vanilla WireGuard is not hard to use at all, it's by far the easiest to configure VPN software. Some routers have it built in, and some have packages to instal
by kube-system 5y ago
Vanilla WireGuard is not hard to use at all, it's by far the easiest to configure VPN software.
Some routers have it built in, and some have packages to install it, and the official GUI clients work well: https://www.wireguard.com/install/ https://www.wireguard.com/install/
If you can't run it on your router, you can just set it up on a linux VM and forward a port as necessary.
The configuration file is quite simple once you get the hang of it, you've basically just got:
1. a public/private key that you exchange between connected machines
2. the address of the tunnel, locally
3. the address/port to get to the other end
4. what traffic you want to send over the tunnel
- daemoens 5y agoAn easier method is to just use PiVPN https://www.pivpn.io https://www.pivpn.io. It's much faster to setup and easier to manage with extremely simple commands.
- kube-system 5y agoI've looked at PiVPN, but it looks like more work than many of the packages available for routers. e.g. dd-wrt, pfsense, opnsense all have point-and-click configuration pages.
- EricE 5y agoNot at all. Maybe three terminal commands tops to configure and add a user for yourself. Once the text config file is generated just import it on your client and you are done. As long as you have forwarded the appropriate port through your firewall that's literally all it is to it. Of course if you have a firewall with it built in, then use that. However for pfSense and OpnSense wireguard runs in user mode and not the kernel, so depending on your traffic the pi may be faster since wireguard is compiled into the kernel with piVPN. Which can cause fun issues if there is a kernel update you aren't prepared for - was my only real problem with piVPN/Wireguard but it wasn't too hard to recover once I figured out what was going on :)
- artificialLimbs 5y agoI'm not sure how this is possible. With pivpn: install pivpn, open router port & forward (automatically configured and optionally changed during setup), type 'pivpn add' at the command line for every device I want. Copy the outputted config files to device and import into wg client. Done.
- viraptor 5y agoZeroTier is even easier. 1. Install the package, 2. zerotier-cli join (your network id), 3. Flip the new node state to enabled in the control panel. No other config need unless you want specific network config/filters.