4 ms·
I don't understand why people use the attiny85... The Atmega328 based boards have far wider software support in the arduino ecosystem, so you will typically b
by londons_explore 5y ago
I don't understand why people use the attiny85... The Atmega328 based boards have far wider software support in the arduino ecosystem, so you will typically be able to prototype a project in minutes instead of hours, and the dev boards cost the same, but the 328 ones have more of pretty much everything.
The only benefit of the attiny seems to be that you can save a few millimeters of board space, but if that's your concern there are plenty of far smaller, cheaper and more capable microcontrollers in BGA packages.
- tpmoney 5y agoThe obvious answer would probably be the size and the dip formfactor. Sure you can get more capable BGA packaged chips, but how many hobbyists have the ability to properly solder in a BGA?
- londons_explore 5y agoThe 328 is also available in dip...
- bavell 5y agoI wanted to gain experience in embedded programming at a lower level than Arduino (i.e. pure C & bitbanging). They're dirt cheap and also simple enough that I can read through the whole datasheet and pretty much understand everything. It's also kind of a fun challenge working within the limitations on both the HW and SW side.
- stavros 5y agoI was intrigued by "dirt cheap" and went to buy a few tens, but they're apparently $2.5 or so each! I can get an ESP8266 for that amount, which has tons more processing power, RAM, space, and has WiFi. I really can't see why I'd use an ATTiny over that, unless the former cost $0.20 or so.