5 ms·
This is modern electronic design in a nutshell. The large-scale physical design is as simple as possible (just regular wiring), the individual components are a
by HPsquared 5y ago
This is modern electronic design in a nutshell.
The large-scale physical design is as simple as possible (just regular wiring), the individual components are all "smart" (Christmas lights each with their own integrated IC, doesn't get more embedded than that) and addressable via a communication protocol.
Imagine how difficult the wiring would be to have 100 addressable lights that didn't use this arrangement!
- kurthr 5y agoWhat is interesting is that one could in fact do this with a single wire. You might eventually see something like this for micro-LED display solutions. The key is to drive a current and control the voltage at both ends of a string such that each LED detects modulation and bypasses (itself) or consumes power (in-line). That might be relevant where the strength of a single (e.g. steel) wire was used to support a long string. By driving relatively low (max RGB) current at higher voltages and time (e.g. PWM) sequencing the light modulation. In a simple case, imaging there are 100 RGB lights, half of them excited on each polarity and bypassed with a 0.2V Schottky stacking to +/-10V minimum (for digital data) at <100mA. You might synchronize and send data to the smart lights each "zero crossing" and get away +/-50Vpp for the string by only having 10 (12.5%) stacked (inline) on at any one time (a controller for the LED FETs can stay awake on a capacitor). As long as you run at a few kHz you won't have noticeable flicker, capacitive and you can update with a few bits per light each cycle. More complex designs could use FETs to improve data link efficiency of the minimum voltage and higher current (lower PWM times) could substantially reduce peak voltage to +/-5V or so.
- IgorPartola 5y agoYou don’t need individual data lines to address each LED. A serial bus and a microcontroller would be enough. The only difference is that here there is no dedicated data line/lines. 1-wire is a similarly clever protocol.
- wyager 5y agoIn 10 years every one of these LEDs will be running an IPv6 stack, and they'll still be using the same wire-and-glue construction.
- theamk 5y agoI dunno... I2C bus was designed in 1982 and it is still in the wide use today, and no replacement is in sight (for the "low speed inter-board" use case). The hardware world moves much slower than software one, and the if the designs work, they are rarely replaced.
- Freak_NL 5y agoAll of them on wifi… Imagine the utter hell of living in an apartment building surrounded by neighbours blasting every Hertz of the wifi-spectrum with hundreds of cheap devices.
- eulers_secret 5y agoThis is now, haha. I can see over 200 APs from my bed (1/2ish are xfinity wifi). Fortunately my place is so small a 100’ cat-5 cable reaches any point in it, so I just use wired. Wifi barely works. Considering wifi-6, but I can’t figure out if it helps with this type of congestion or not…
- 323 5y agoIn 20 years each LED will be a pod in a Kubernetes cluster, running Node.JS and the output color will be controlled through React interacting with blockchain smart contracts.
- kingcharles 5y agoEach LED will have its own NFT.
- rini17 5y agoAnd they will still flicker annoyingly.
- wccrawford 5y agoMost addressable LED strings have 3 or 4 wires, with 1 or 2 being data. The ones in the article have only 2 wires, positive and negative.