4 ms·
Is it possible to sharpen such a thing when it does get dull, or does that require a professional? In between sharpenings, does a steel work? (Sorry, I don't
by jfengel 5y ago
Is it possible to sharpen such a thing when it does get dull, or does that require a professional?
In between sharpenings, does a steel work?
(Sorry, I don't know much about steel or knife making. I just appreciate a really good kitchen knife.)
- bob_loblaw 5y agoWhen we think of knife performance, it is the geometry of the blade that is the most important. I can give you a knife in MagnaCut with a thick edge. It won't cut for crap. So you want a nice, thin edge. Thin edges tend to roll/chip more easily. That is why you want a harder steel. So if MagnaCut is run hard, it will most likely dull before rolling or chipping. It will still cut, especially if you have think geometry. Once a blade starts to roll/chip, performance really suffers. That's when you need to sharpen. I have never sharpened MagnaCut, but it only has 4% vanadium (the hardest carbide) and 2% niobium (another hard carbide). You can probably get away with something like the Shapton Pro line of stones. They are readily available.
- kragen 5y agoHmm, is vanadium carbide really harder than tungsten carbide, even at room temperature?
- bob_loblaw 5y agoAll the research I have seen says vanadium is harder. That said, Sandrin Knives makes cutlery with a blade of nothing but tungsten carbide. This will outperform any steel easily. I have not seen a blade of nothing but vanadium. No idea if that is even possible. https://usa.sandrinknives.com/ https://usa.sandrinknives.com/
- kragen 5y agoInteresting, thanks!
- spekcular 5y agobob, what's your favorite resource(s) on learning to sharpen – both technique and theory (geometry, etc.)? I tried to get into the Cliff Stamp stuff, but it was really hard because everything was spread out across a zillion forum posts and YouTube videos.
- rdtwo 5y agoYeah I’ve bought a variety of tools over the years and all of them kind of suck. You need to be some sort of master craftsman with infinite time to use many of the sharpening techniques and tools or have already almost perfectly sharp knives.
- exhilaration 5y agoYou should Google your location + knife sharpening. There's probably a master craftsman within a few minutes drive of you that will sharpen your blades for a very reasonable price. There's a guy near me that will do small pocket knives for $2.50, prices go up from there. All of the local landscaping companies use him for their mower blades and chainsaws.
- rdtwo 5y agoThere is a fantastic place in Seattle that does it at 2$ an inch or something. Just takes about a month
- mafm 5y agoI'm not bob, but I bought a ruixin pro 8 (~40AUD) and 3 diamond stones (~5AUD a piece) on aliexpress a couple of weeks ago. Watched a YouTube video and got half a dozen kitchen knives sharp enough to shave arm hair in about an hour. They seem to be holding their edges reasonably well a couple of weeks later. I'd previously not had much success with Japanese water stones and with the lansky(?) gadget. It seems like the key part of the process is (a) detecting when you have formed a burr so you know when to change sides/move to the next grit and (b) stropping at the end (get the leather strip with polishing wax). The Chinese gadget is a bit crude but was honestly surprisingly effective. I don't think the theory is that complicated but getting good practical results reliably can be a bit tricky. The gadget seems to work quite well for that. Ps: Just looked at Cliff Stamp's sharpening site. I think that's an order of magnitude sharper than I was going for with my kitchen knives.