3 ms·
I'd wanted a laser on a 3D printer years ago, to heat a spot on the layer below just ahead of laying new filament. 3D filament printing is, after all, welding a
by Animats 5y ago
I'd wanted a laser on a 3D printer years ago, to heat a spot on the layer below just ahead of laying new filament. 3D filament printing is, after all, welding a hot thing to a cold thing, which never works well. Not much laser power, just 1-2 watts. Might be able to fix the "weaker in the layering direction" problem.
- comboy 5y agoThat's a neat idea. Somebody did this [1]. Not sure if it's worth the effort to achieve 20% strength increase, but potentially with some fine tuning this could probably allow lower extraction temperature and more flexibility with shape / more precise prints. Likely still not comparable SLA. 1. https://www.mdpi.com/2504-4494/5/4/115/pdf https://www.mdpi.com/2504-4494/5/4/115/pdf
- Animats 5y agoThat's new. Work in 2021. Interesting. They're vague about the laser power. Also, they only had one laser in a fixed position, so they could only print in one direction, moving towards the laser. You probably need something like 3 lasers, 120 degrees apart, switched so that the energy is always being applied ahead of the filament. If this increased the range of easily printable materials, it would be quite useful.
- contingencies 5y agoWith (laser or traditional) welding of metals it gets to the point where you need to flood the area with shielding gases (eg. argon/helium/nitrogen) during the weld to prohibit poor surface qualities (due to plasma formation, oxidation, etc), and that the flow rate requirement and geometric matching of the airflow-assist structure ('shoe') becomes critical (sometimes on both sides). Basically, a generic solution has severe limitations in material, speed and finish terms. I am no chemist but would generally assume the same to be true for many food related substances. Polymers bonding will often respond better to a mix of focused ultrasonics and pressure than simply thermal energy. Alternative, use glue.
- robbedpeter 5y agoIt can be welding a hot thing to a cold thing, but if you dial in the layer height and print speed, the heat from the hotend is going to partially melt the area being printed on, resulting in a solid bond. Maintaining a heated enclosure and print bed makes this easier, and eliminates all (or almost all) the warps, layering gaps, and pockets. Slower, smaller layers means more layers and more time per layer. It then becomes a tradeoff of part strength vs print time. Infill selection and parameters let you dial that in after you get layer bonding and temperature set up. Printing solid transparent filament parts is done this way. Adding a laser would accomplish the same thing, but would still require slower speeds and the enclosure to prevent warping.