3 ms·
I think a lot of SMBs are the holdouts for IPv6; their entire IT infrastructure is IPv4, and switching will be expensive because every router, subnet, VLAN, &c.
by aidenn0 5y ago
I think a lot of SMBs are the holdouts for IPv6; their entire IT infrastructure is IPv4, and switching will be expensive because every router, subnet, VLAN, &c. must be upgraded. Small home networks are comparatively easy once all clients support IPv6: switch from a single subnet in the private range to a single /64 and add a stateful firewall. Since SMBs can run a lot of clients with very few (or even one!) public IP, IPv4 addresses will need to become much more expensive (or critical remote services will need to switch to IPv6 only) before it's cheaper to upgrade internal infrastructure to IPv6.
Note that NAT64/464XLAT solve the reverse problem. NAT-PT was the theoretical solution, but see RFC 4966 for all the reasons why that was a failure.
- wmf 5y agoMany SMBs should probably go full cloud and once that's done they can "downgrade" the office network to zero-trust and maybe deploy IPv6 at the same time.
- labcomputer 5y agoColor me skeptical. It’s true that many SMB network infrastructure devices have poor support for IPv6, particularly w.r.t. the management interface. But IPv6 support is old at this point. Very few things have no (as opposed to inconvenient) IPv6 support. For heavens sake, there are versions of IRIX and VMS/VAX with IPv6 support. Those OSes run exclusively on hardware that hasn’t been manufactured for two decades, and the companies that released them have been defunct for almost as long. Windows XP (deprecated over 10 years ago) supports it. MacOS 10.7 (released 10 years ago) supports it. In other words, if you’re willing to run network management from a dual-stack host, you can probably switch over all “regular hosts” today at zero hardware cost. You have to be running seriously old hardware and software to not have IPv6 support today. So old that it should be on an air-gapped network anyway. The only relatively common exception is Cisco Meraki and some cheap consumer-level AIO router/APs.
- aidenn0 5y agoI'm not saying there are devices that don't support IPv6 (though there are), I'm saying the IT costs of reconfiguring the infra for IPv6 are higher than the costs of paying many times the current going rate for an IPv4 address.