3 ms·
Sadly, there's not much in the way of equipment for this. I could really use two small 10BaseT-1 to 10BaseT converters, preferably both powered from one end.
by toast0 5y ago
Sadly, there's not much in the way of equipment for this. I could really use two small 10BaseT-1 to 10BaseT converters, preferably both powered from one end.
- throw0101a 5y agoSeems to be mostly in the automative and industrial space, with some embedded stuff. I could also see it being useful for door security (badge readers, latch control).
- toast0 5y agoFor me, I've got a gate with a keypad. It's got an ethernet port, but they only ran 3 pair to it, and it works best with 2 pair for voice communications, so I've only got one pair for data, not enough to use.
- cpgxiii 5y agoSince most of the 1000Base-T1 gear is still unreasonably expensive/effectively impossible to get quickly in small quantities, you can run 100mbps and 1gbps Ethernet over "reasonable" lengths of single twisted pair using MoCA adapters plus coax->twisted pair baluns. Achievable cable length will obviously depend on EMI conditions, but I've had reasonable success with this method on twisted pairs in industrial robots.
- neilalexander 5y agoGIGA G4201TM modems are built for exactly this, using the G.hn standard, over a single pair. I’ve been using these to avoid digging into walls to replace wiring — they claim to sync at up to 1700mbps and, even in the real world, I’m saturating the 1000BASE-T ports.