4 ms·
Isn't the orange piece hollow, so it should be possible to push something in it and drive the pin out (moving the red piece into the green one) after aligning t
by userbinator 5y ago
Isn't the orange piece hollow, so it should be possible to push something in it and drive the pin out (moving the red piece into the green one) after aligning the splines?
When it comes to attaching the body to the underframe, axles are inserted into holes in the side and, while they do not mate with an axle hole inside the body, they cannot be removed without putting the mechanised beast on its side, shaking it, and hoping for the best.
That is definitely what is called a "blind pin" in machining, with a tighter interference fit, and they are usually avoided in components meant to be serviceable, since removing them requires drilling them out.
It seems amusingly ironic that with the increase in the difficulty of disassembling consumer products, Lego also follows suit.
- rtkwe 5y agoNo you can't push the red short pin through the grey piece, it's a 6538c [0,1] by the looks of it and those have a small wall in the middle to stop push through. They're meant to be used to connect two Technic axels and just sit on the two ends. [0] https://www.bricklink.com/v2/catalog/catalogitem.page?id=67471#T=C https://www.bricklink.com/v2/catalog/catalogitem.page?id=674... [1] https://img.bricklink.com/ItemImage/EXTN/17834.png https://img.bricklink.com/ItemImage/EXTN/17834.png
- deleted 5y ago[deleted]
- bena 5y agoThe orange pin is hollow, but the red axle is behind it is not. That gray axle sleeve has a stop about halfway through so you can't push an axle all the way through. It's meant to join two axles. You could omit the green sleeve as it is completely smooth on the inside. That will give you better access to the dark gray axle, but the sleeve is probably there to provide structural support to the frame. They might do a small update where they replace the "4 axle with stop" with a "5 axle with stop" and put a bushing on the outside to provide support between the stop and the frame. Provided, of course, that there's a brick's width of room where that assembly goes. Edit: I just looked up the instructions for 75313 and found the section with the assembly. The assembly is the "hip" joint, where the leg connects with the main body. The assembly is connected so that the offending axles are parallel to the ground. The dark gray axle points inward and it looks like, at least on the front legs, it's too close to another frame to extend the pin so that it sits outside the frame. https://www.lego.com/cdn/product-assets/product.bi.core.pdf/6393612.pdf https://www.lego.com/cdn/product-assets/product.bi.core.pdf/...