2 ms·
I was talking about the fact that the center of lift is ahead of the center of mass of a circularly symmetric wing with positive lift. [1] That force would nor
by londons_explore 5y ago
I was talking about the fact that the center of lift is ahead of the center of mass of a circularly symmetric wing with positive lift. [1]
That force would normally cause an aircraft to 'pitch up' (and hence planes have tail's and carefully balanced weight to stop this happening). In a frisbee, the gyroscopic effect means that this 'pitch up' force actually translates into a 'roll right' motion. By making the rim heavier, you can make this happen slower, but as far as I can see, you can never eliminate it entirely.
My fin is on the outer edge of the disc, spinning with it, so it can oscillate at ~50Hz to get independant roll and pitch control, while also being able to trade off loss of angular momentum vs lift. It also has the benefit that it can be made from cardboard in a single pressing with the disc with no glue or assembly labor.
[1]: http://ffden-2.phys.uaf.edu/645fall2003_web.dir/Mike_Abrams/Lift.h3.jpg http://ffden-2.phys.uaf.edu/645fall2003_web.dir/Mike_Abrams/...
- icegreentea2 5y agoAh hm. I wonder which one of our two effects is dominant. I can see that your explanation must plainly exist - it's just not part of the standard "intuitive" model taught to frisbee players. That's a really clever fin design. If the dominant component of rotation was due to the center of pressure being ahead of the center of mass, could you to use timing of the fin being in a "high drag" configuration to pull the time averaged center of pressure back towards to the center of mass?
- londons_explore 5y ago> could you to use timing [...] back towards to the center of mass? Yes, but sadly the effect isn't large enough until you end up with a very large fin and a very powerful actuator to move it. That difficulty is what made me put the project on the backburner for now.