3 ms·
I switched my printers over to Klipper and have been overjoyed with the change. It’s a different style of firmware where all the gcode interpretation and motio
by sokoloff 5y ago
I switched my printers over to Klipper and have been overjoyed with the change.
It’s a different style of firmware where all the gcode interpretation and motion calculations are done on the more powerful raspberry pi* and only the motion control pulse generation is done on the printer’s board.
You get very precise step control as a result and with no start-stop blobbing within a layer.
If you don’t want to go that far, look into max resolution settings in your slicer** to reduce tiny moves which might be overrunning the printer’s ability to process. Note that this is still useful with Klipper as well.
* I’m using zero-w Pi, which is still way more powerful than a printer board.
** https://m.youtube.com/watch?v=Hvw3DrVAeTA https://m.youtube.com/watch?v=Hvw3DrVAeTA
- jcims 5y agoNice! thank you!