4 ms·
As someone working in CNC area (CAM posts and automation) you explained this very well. Especially I like that you mentioned the tendency to use just a tip of t
by Kosirich 5y ago
As someone working in CNC area (CAM posts and automation) you explained this very well. Especially I like that you mentioned the tendency to use just a tip of the tool, which I know even machinists tend to do.
Perhaps also mention the ware if certain position on the table is used constantly?
I would add that when you go close or bellow 0.01 then also perfectly controlling your holders (runout) and being wary that the tool, no matter how stiff, bends as well, so you should control your overhangs as well.
- abakker 5y agoThe point about using only one part of the table is funny to me. A lot of hobbyists build 4x8 or larger machines, and then always set g54 to the same spot and use only that (because different work offsets on your gantry axis are often very hard to reach!). I guess with hobby machines it doesn't matter much if you use linear rails because you basically will never wear them out, but I found with my previous v wheel machine that this was a very real problem.