4 ms·
Corrosion is a concern, all over but especially on the inner cylinder that has to seal. The seals are probably OK but they're important and redo them anyway whe
by h2odragon 5y ago
Corrosion is a concern, all over but especially on the inner cylinder that has to seal. The seals are probably OK but they're important and redo them anyway when its open. The fluid will pick up some water and thats a whole hydraulic system flush, once you get "too much".
Then you've got bearings and grease ports and channels that not only don't necessarily like water; but you're not operating in clean water either and that compounds all the problems.
Noting almost total ignorance of the realities: I forsee vacuum hydraulics problems including keeping seals tight, the inevitable oil coating on cylinders boiling off and getting polymerized residue buildup. Double enclose all the actuators and have another seal system so you can have a moving thing poking out of a hull, as is done for boats, will probably be necessary... and that'll have its own problems at the actuation points i bet.