3 ms·
Why did you do alignment via jig? I've done this kind of manual configuration in the past when I needed to align two independently-controlled axes to each other
by HeyLaughingBoy 5y ago
Why did you do alignment via jig? I've done this kind of manual configuration in the past when I needed to align two independently-controlled axes to each other (a pick & place handing off an object to another pick & place) , but for registration of a single axis, I'd normally use a "home" sensor.
- aarondf 5y agoThe jig aligns two axes! The jig is placed at a specific tooth (x) with a known Y offset. By placing the pen in the hole on the jig, both x & y are resolved