4 ms·
As someone with lots of experience on small block Fords, but nothing Chrysler, I would say that a 3/4" spacer under a 600-750 CFM double pumper adding 40 HP jus
by dotancohen 5y ago
As someone with lots of experience on small block Fords, but nothing Chrysler, I would say that a 3/4" spacer under a 600-750 CFM double pumper adding 40 HP just solved either the manifold leak or the throttle cable binding. Did peak power occur at the same RPM (i.e. was it really putting out more torque)? How fast was it spinning, and at what RPM did the power really start dropping off?
Was this measuring at the flywheel or at the wheels? I'm genuinely interested, it's been a long time since I've had grease under my fingernails.
- WalterBright 5y agoThe engine had just been built and I took it to a dyno company to be tuned. It was mounted in their machine, so it was at the flywheel. The guy doing it remarked that it really made a dramatic difference, it seems the original parts configuration was a pessimizer. I'm not too surprised, because the engine was heavily modified and so would exhibit very different flow characteristics from the stock configuration. I don't remember the RPMs. It's a bored, stroked, and rollered 340 engine, and peaked at just under 400 hp. The dyno guy normally worked with drag engines, and told me I was an idiot because I had the stock heads modified rather than getting aftermarket performance heads, a mistake that likely cost me another 40 hp. The engine was built as a sleeper, so the only way you can tell there's some monkey business going on is the oversize aluminum radiator, but nobody notices that :-) But they notice when I start it.
- dotancohen 5y agoSounds nice. Yeah, a lot of engines of the era were detuned at the factory for regulatory and other (supposedly e.g. insurance, later emissions) reasons. If you already had other top end mods, e.g. good headers and ported heads (seems you did) then sometimes a small change could open up a bottleneck. Thanks for sharing!