3 ms·
“only two screws hold down the PCB to the case“ Nowadays, that’s two more than a product with cutthroat pricing should have. Engineering tolerances, even at lo
by Someone 5y ago
“only two screws hold down the PCB to the case“
Nowadays, that’s two more than a product with cutthroat pricing should have. Engineering tolerances, even at low cost, are good enough to clamp the PCB in place.
- anyfoo 5y agoThe funny part is that they obviously planned for much more.
- Someone 5y agoOr their manufacturing was so imprecise that they had to make more than two holes to (most of the time) get at least two that were in the right-enough place and where the screw would actually “grip” the plastic. I expect, though, that the first batch used all holes and that this was a matter of using excess inventory with too many holes after realizing that they could do with fewer ones.
- anyfoo 5y agoInteresting with the imprecise manufacturing, haven't thought about it like that (and obviously don't know anything about the mechanical part of manufacturing). I'm better at judging the electronics/computer design, and there it's obvious to me that they went out of their way to stay cheap.
- Too 5y agoAre you Munroe Live on Youtube? It's a channel where they disassemble and review the internals of EVs. Any time he comes across a screw (threaded fastener), which happens all the time, he turns red and politely hints how the designers could have done a much better job.