Fusion scientist here (no connection with MIT/CFS). This is in fact a very big deal. One of the chief complaints about fusion energy is the low power density (f

Fusion scientist here (no connection with MIT/CFS). This is in fact a very big deal. One of the chief complaints about fusion energy is the low power density (for ITER-like tokamak <<1MW/m^3, vs ~ 100MW/m^3 for a LWR fission core). The low power density is the primary reason that ITER is as large (and hence expensive) as it is. Fusion power density scales like B^4. So if CFS can get 2x the magnetic field, then they can make the plasma volume 16x smaller, which might equate to big savings in cost and construction time. (It doesn't make sense to go much smaller than their ARC reactor design though -- the plasma already takes up only a fraction of the volume of the core at that scale, so compressing the plasma further doesn't improve the power density. If you can increase the field even more, which REBCO seems to allow, then you would rather just pack more power into a device about the size of ARC. So don't expect to put one of these on your DeLorean.) There are definitely other challenges/limitations. For one, this approach increases the heat flux that the inner wall of the reactor will have to survive. The localized heat flux of the exhaust stream is expected to rival the heat flux of re-entry from orbit (20 MW/m^2) and could be as high as the power flux from the surface of the sun (~60MW/m^2). 20MW/m^2 is on the hairy edge of what's possible with today's technology, and that's without all the complications of neutron damage, plasma bombardment, etc. The current thinking is to spike the outer layer of the plasma with neon or nitrogen, to radiate most of the power as photons, but there are limitations & risks to that idea as well. Commonwealth's plan for SPARC (last I heard) was to oscillate the exhaust stream back & forth across the absorber plate to reduce the average heat flux. The nuclear engineering side of fusion has been underfunded for a long time, so there's much that needs to be done on that front, in terms of demonstrating that the breeding of tritium from lithium can be done efficiently & without too much losses. Also, we should be developing better structural materials that can withstand neutron damage & not become (as) radioactive. It's still very much an open question as to whether fusion could be made economical, even though it seems like it should be technically possible.