3 ms·
Compression fittings are generally more convenient and cost effective than Pex or copper in small volumes and with little experience. The only downside as you n
by lazide 5y ago
Compression fittings are generally more convenient and cost effective than Pex or copper in small volumes and with little experience. The only downside as you note is leaks if someone doesn’t do them right (or as time passes), but that tends to be more of problem at higher household service line pressures (60+ psi)
If it is a low pressure recirculation system, you can get by with almost no tools and most people if they read instructions at all probably won’t mess it up bad enough to have a leak.
The brake line connectors could be interesting, but aren’t likely to work well stock - brakes are very low
flow, high pressure as they are ‘dead ended’ hydraulic systems used to transfer force, not loops for cooling purposes. Also those bolts can work loose, and then you have leaks. Brakes require experienced technicians or people die, so folks working on brakes tend to be the more qualified and experienced mechanics, and they make sure to torque to spec, clean surfaces, do proper prep, etc. which is not what you want to have to worry about from an idiot proofing perspective.
- heelix 5y agoMan, if only copper was easy. One of the gotchas is most connectors for CPU, graphics cards, and chipsets tend to use the G1/4" ends up having metric on the other side. 12mm or 13mm. Most copper pipe is .5", which works out to about 12.7mm. You have to be really picky with couplers if you want to use copper. PTEG/Acrylic is less great for things that would be banged around and a pain, compared to if you know how to actually do copper.
- namibj 5y agoOr you just use actual metric copper pipes in 12mm....
- lazide 5y agoGood luck finding those easily around here!
- namibj 5y agoYeah, it's one of the more practically relevant downsides of not really switching to metric. It could start with mandating metric-based norms for building parts in new designs for federally-funded construction, as well as mandating in consumer protection regulation that the metric measurements have to be no less prominent than non-metric units (well, technically that'd be about SI units). At some point potentially requiring operations with large-enough warehouses to offer the metric-norm equivalents for parts according to non-metric legacy norms, if they reach some threshold with inventory turnover on those parts where it'd not be a big burden to also offer those metric equivalents. But yeah, I know the feeling of foreign norm components being hard to get, from when I tried to get the screws used for consumer-grade camera tripod mounts. They are iirc 1/4" machine screws. Roughly like M6, but far from compatible.
- lazide 5y agoYup, or even equipment with mixed standards that are kinda close so you have to start pulling out multiple thread gauges just to figure out WHY you're particularly screwed, and for how long will you remain so. Plumbing is rife with it near as I can tell. Semi-random differences in thread pitches, metric vs standard, etc. everywhere.