5 ms·
Old Teslas (like 5+ years) will lose net when 3g goes. You can do a computer upgrade but I don’t think it’s cheap ($500-$1500 range offhand)
by brianwawok 5y ago
Old Teslas (like 5+ years) will lose net when 3g goes. You can do a computer upgrade but I don’t think it’s cheap ($500-$1500 range offhand)
- toomuchtodo 5y agoIt’s really annoying this isn’t software defined for future proofing. As long as your RF hardware is robust onboard, the rest can be done in software.
- johnchristopher 5y agoAre you suggesting some 3G RF hardware can be retrofitted with software patches to be compatible with 4G networks ?
- wmf 5y agoThis is theoretically possible (SDR) but it's very expensive. (Before anyone replies about $20 SDRs, those aren't even close to 4G/5G capable.)
- jrockway 5y agoIndeeed. Last time I looked these chips were $1300 each in quantities of 1000. Too expensive for even a luxury car. I think the answer here is an internal USB modem or something. Easy to upgrade. Just up to the car manufacturer to commit to writing new drivers. (I assume that they don't want to do this, so are probably happy when technology changes out from under them. Everyone has to buy a new car!)
- toomuchtodo 5y agoWhat makes this silicon so expensive?
- wmf 5y agoFuture-proofing puts you on the wrong side of Moore's Law. Let's say 4G requires 10x the transistors of 3G. In reality that's not a problem because 4G came out 10 years after 3G so transistor costs came down 10x or more. But if you wanted to build a 4G-upgradeable radio years early you'd have to pay for that 10x performance upfront using older and more expensive technology. This same argument applies to future-proofing other tech like video codecs as well.
- mschuster91 5y ago- Car stuff has to be certified in order to be road legal (in Europe, ECE marked) - Car stuff has to deal with a way wider temperature range than normal consumer stuff (-40 to +125 °C). That is the thing that makes silicon so expensive. - Car stuff has to deal with vibrations and mechanical stress, meaning more expensive PCBs, less options for solder (remember the infamous NVIDIA solder issue of ~2010?) and connectors - Car voltage regulation is a hot mess, at least for ICE vehicles - IIRC during engine start, voltages can drop to something like 6-ish volts and after that (or during battery disconnects/other load dumps) into 120-ish volts, and the voltage has an awful lot of ripple because usual generators are AC that's driven through a diode rectifier, with the battery acting as stabilizer. - Most stuff in cars requires hours of work to replace it - Tesla were to my knowledge the first ones who did software updates outside of shop visits at all.
- tpmx 5y agoRegarding the temperature range; this procides a bit more detail and nuance: https://electronics.stackexchange.com/questions/301826/how-to-determine-temperature-grade-for-automotive-electronic-components https://electronics.stackexchange.com/questions/301826/how-t...
- jrockway 5y agoHigh complexity, low volumes, I would imagine. A few of the answers below talk about it being a car part but SDRs that can do 3G/4G are targeted at people developing cheaper chips. Electronic test gear is much more expensive than cars (at least at the bleeding edge), so the pricing doesn't preclude it from being used there.
- someguydave 5y agothe radio cannot be software defined (and user modifiable) for type acceptance and regulatory reasons
- deleted 5y ago[deleted]
- ac29 5y agoIn what country? The FCC certainly allows SDR to be certified. "User modifiable" is sufficiently broad as to be nearly meaningless.
- someguydave 5y agohttps://softwarefreedom.org/resources/2007/fcc-sdr-whitepaper.html https://softwarefreedom.org/resources/2007/fcc-sdr-whitepape...
- ac29 5y agoHere's the actual text on restrictions for SDR: https://www.law.cornell.edu/cfr/text/47/2.944 https://www.law.cornell.edu/cfr/text/47/2.944 The FCC defines SDR here extremely broadly, any radio which "frequency range, modulation type or maximum output power (either radiated or conducted)" can be changed. This describes a substantial portion of radios - including many if not most WiFi access points. They are legal and many US companies design, manufacture, and/or sell these types of radios (I work for one of them).
- someguydave 5y agoAbsolutely they are legal to sell, but you have to go through type acceptance under part 15, and then you need to make it so the user cannot modify them. “ The rules require any manufacturer certifying a device under the new process to take steps to prevent “unauthorized” changes to the software on the device that might alter its radio frequency and power parameters in a way that takes it out of compliance with the regulations known as FCC Part 15 regulations.” Test equipment is exempt because it is not licensed as an intentional emitter under part 15.
- Hamuko 5y ago$500 to $1500 sounds relatively cheap for a Tesla repair since a battery issue can be in the tens of thousands (because they want to replace the entire battery) and even relatively minor body damage can be in the thousands or the tens of thousands.
- tpmx 5y agoThey really should have used an easily replaceable mPCIe cellular module. $50 replacement cost. Interface has been around since 2005.
- techrat 5y agoAnd $1450 labor.
- brianwawok 5y agoI have actually found Tesla labor prices very reasonable.
- toyg 5y agoCar manufacturers don't even try to pretend that their prices have anything to do with the actual costs of components. You want an "original X" part? That will be $$$$, thank you very much.
- deleted 5y ago[deleted]
- vetinari 5y agoJust because the old modules were mPCIe doesn't mean a new one will be too. I have an Thinkpad T430s, that came with mPCIe 3G modem; for LTE, it was possible to find a replacement, but for 5G, I don't expect there will be any (any whitelists in firmware aside). Or similarly, I have an openwrt router with mPCIe 802.11-ac wifi (Turris Omnia). It is not possible to replace them with -ax adapters, they all have m.2 interface. With cars and other long-used goods I would expect the same problems.
- tpmx 5y agoSure, most have USB-only connections and some have actual PCIe connections (I suppose). And then there's the fragmentation at the software/AT command level. Still, Tesla could have spent the software effort required to make it work with a few of the most common 3G/4G/(5G) modules from reputable manufacturers.
- xedeon 5y agoThat's not accurate. You don't need to upgrade the MCU/infotainment computer and the retrofit is only $200. "A source has informed me that due to AT&T shutting down its 3G network by Feb 2022, Model S's without an LTE-capable modem will lose connectivity features unless connected to WiFi. HOWEVER, Tesla will offer retrofits for $200. Affected vehicles are pre June 2015." "Tesla will be offering retrofits for these vehicles for a bargain price of only $200, even though the vehicles affected by this could be up to nine years old." Source:https://twitter.com/SawyerMerritt/status/1415851250055323648 https://twitter.com/SawyerMerritt/status/1415851250055323648
- ssheth 5y agoSee https://www.tesla.com/support/update-3g-services https://www.tesla.com/support/update-3g-services They're going to upgrade the modems to LTE for $200 each.
- chasil 5y agoI really appreciate my 2011 Civic's lack of a cellular modem.
- fogihujy 5y agoDitto with our 2003 Citroën. This always online paradigm will cause more and more problems down the road, as the first IoT generations lose Internet access.
- brianwawok 5y agoDo you? Because when it's -10F here, I can remote start my car, even if outside remote start range. Rather nice to always have a toasty car (or cool in summer).
- brianwawok 5y agoOkay that's good. Last I heard was that they stopped doing daughter board upgrades, and you had to swap your entire computer. Things like this tend to change pretty fast/often in Tesla land, so can't always keep up. (Also don't have a 2014 Model S so doesn't impact me personally)