3 ms·
Gears are usually slightly smaller than design size for clearance sake (and to make cutting the teeth easier). I imagine this tolerance disappears to almost zer
by mikewarot 5y ago
Gears are usually slightly smaller than design size for clearance sake (and to make cutting the teeth easier). I imagine this tolerance disappears to almost zero in aerospace, though.
If the outer diameter of a gear tooth is too large, it can bind with the root of the matching gear, and this can cause rapid wear, and an unplanned disassembly at some point very early in the service life.
- WalterBright 5y agoI can say that the aviation gears are far better cut and fitted than the ones you'll find in a car transmission! I once brought to work some gears from my car tranny, and the other engineers were horrified at them.