3 ms·
The diagram is bad; the context is worse. Firstly, "volts of power" even by itself is very, very poor language in an EE topic, never mind "positive and negativ
by kazinator 5y ago
The diagram is bad; the context is worse.
Firstly, "volts of power" even by itself is very, very poor language in an EE topic, never mind "positive and negative sides of 6V of power".
By labeling two nodes of a circuit as -6V and +6V, you are showing that that's what the voltages are at those points (relative to some common reference) and thus the potential difference between them is 12V. That's the standard interpretation when you put a number next to a node of the circuit, and put a V suffix on it.
What the diagram is communicating, to someone who can read circuits, is that R2 is dropping 12V, on a DC supply of 9V.
The diagram is also neglecting to show some ground reference that is understandable as 0V, to indicate relative to what are those other voltages being referenced.
By convention, the default place for that would be the - terminal of the battery. So the bottom of R2 would be shown as 0V, and the middle of the voltage divider, top of R2, as 6V (which matches what is already notated).
It may be that the -6V is supposed to be referenced from the top of the R2 resistor, but this is confusing and inconsistent; all voltages for the same circuit should use the same reference.
If you want to show that the bottom of R2 is down 6V from the top, you can label those nodes of the circuit, like R2a and R2b, and then write a formula: R2b - R2a = -6V which shows that R2b is -6V down from R2a.