3 ms·
I think you're right to be infuriated and the OP should not have complicated things that much. If you are simply attempting to make food to eat, then you can ve
by YeGoblynQueenne 5y ago
I think you're right to be infuriated and the OP should not have complicated
things that much. If you are simply attempting to make food to eat, then you can
very easily do so. If what you want to eat can be eaten raw, eat it raw. If not,
boil it.
Boiling may need a bit of experimentation to get right for some foods, but in
general you need to have a pot big enough to take the full amnount of food, a
sufficient quantity of clean, potable water to fill the pot until it's two cm
over the food once the food is in the pot, and a sufficiently powerful source of
heat to bring the water and the food to a temperarture of 100 degrees Celsius
within a period of time of no more than 10 minutes. Once you have those things,
the pot, the water, and the source of heat, put the food in the pot, add water
to fill the pot to two cm over the food, put the pot on the heat source and turn
the heat source on. At this point it would probably be useful to have a
thermometer so you can directly measure the temperature of the water, but you
can usually observe that the water in the pot is vaporising and confirm that it
is at boiling point. Leave the food to cook until all the water in the pot has
evaporated, but not more than that or the food will burn. Then eat the food.
Remember to turn the heat source off before eating! You may also want to consult
a set of instructions concerning how to clean the pot once it's used.
There may be variations of the procedure, for example if you have a very big
amount of food you may want to adjust the levels of water, but that is something
you can experiment with. In any case, if you can master this technique (but
don't be discouraged if you can't) then you will always have a way to make food
to eat that is, indeed, not a bloody painting.