3 ms·
Like other Prusa Minis, it comes with an "appendix" you must physically break to be able to install unsigned firmware. In the same way as warranty seals, this
by userbinator 5y ago
Like other Prusa Minis, it comes with an "appendix" you must physically break to be able to install unsigned firmware.
In the same way as warranty seals, this sort of stuff can usually be worked around with not a lot of effort. One of the comments there already mentions:
You can test if the "appendix" is the issue by connection BOOT0 and SWDIO to GND. That is all the appendix does.
"There's a few thousand mice but only one cat." "What you can make, we can break."
- PragmaticPulp 5y agoThe point is that you must physically remove it or severe the traces, which is then obvious if the device is returned for a refund or warranty claim. It’s not meant to be complicated. It’s only meant to be easily identified during the RMA process.
- userbinator 5y agoThe point is that it can be done relatively easily, and reversibly. Of course, it probably does act as a filter for low-effort scams.