7 ms·
Some components, mostly capacitors, have the wrong hole spacing for their pins, and leads were bent to fit. That suggests part substitutions during assembly. Ma
by Animats 6y ago
Some components, mostly capacitors, have the wrong hole spacing for their pins, and leads were bent to fit. That suggests part substitutions during assembly. Many of the through-hole components were not pushed all the way down into the board. That suggests overworked assemblers. This was obviously hand-assembled.
The author makes a point that there's a clear division between the AC line side and the DC side. That's required for UL approval, but power supplies do show up without it. The power transformer that crosses the boundary should also have a split bobbin, so the AC line side coil and the output side coil are separated by a barrier, not wound on the same bobbin.
There are worse power supplies.[1]
[1] https://linustechtips.com/topic/515473-teardown-and-review-of-the-turbolink-atx-xg500w-crappy-psu/ https://linustechtips.com/topic/515473-teardown-and-review-o...
- lmilcin 6y ago> The power transformer that crosses the boundary should also have a split bobbin, so the AC line side coil and the output side coil are separated by a barrier, not wound on the same bobbin. Separate bobbin is not required for robust isolation. For example, just right now on my bench there is a medical separation transformer. No separate bobbin (hint: it is toroidal).
- formerly_proven 6y agoI have never seen a split bobbin in an ATX supply — they are bad for efficiency.
- GekkePrutser 6y agoThere's worse power supplies sure but this one is still a mess. I don't see anything obviously dangerous but it's still a dirty ugly design and assembly. Other companies like Delta Electronics manage to cram lots of components in small spaces too but they actually do a good, clean job. Most PCBs with large, heavy through-hole components are still manufactured by hand, by the way.
- deleted 6y ago[deleted]
- TwoBit 6y agoWell he was destroying a power supply to make this report and so maybe there was a budget.
- arkh 6y agoYears ago, Canard PC Hardware (a French magazine) tested some low budget PSU: http://www.x86-secret.com/dossier-36-3000-Alimentation_Noname.html http://www.x86-secret.com/dossier-36-3000-Alimentation_Nonam... their conclusion was to not put those in any PC if you value your other components and maybe your home (lot of fireworks under mild load: https://youtu.be/f6snWfd1v7M?t=60 https://youtu.be/f6snWfd1v7M?t=60 ) One of the constructors attacked them and lost.
- ta988 6y agoSometimes you put the resistors above the PCB to facilitate heat exchange with air cooling.