4 ms·
They probably aren't bothering to. The extreme economics for producing this type of chip are likely acceptable to the stakeholders. Also, there is no reason th
by bob1029 6y ago
They probably aren't bothering to. The extreme economics for producing this type of chip are likely acceptable to the stakeholders.
Also, there is no reason they cant have some redundancy throughout the design so you can fuse off bad parts. It all really depends on the nature of the anticipated vs actual defects, which is an extraordinarily deep rabbit hole to climb into.
- systemvoltage 6y agoI wonder how much this "chip" costs!
- LASR 6y agoProducts like these are often sold as part of a contract to deliver complete solutions + support + maintenance over some number of years. It's hard to estimate a per-unit cost. But suffice to say it would cost similar to other datacenter compute solutions on a performance/$ level.
- aryonoco 6y agoAccording to Anandtech, an arm + leg. Also known as several million.
- meepmorp 6y agoThe previous generation was the $2-3 million range, and these are now in the neighborhood of "several million". Or, arm+leg.
- Pet_Ant 6y agoHow does this fusing work? I assume there are a bunch of wires than are either hot or ground and that determines if part of a chip gets run?
- PeterisP 6y agoI believe you design special fuses on the chip that can be "blown" with a laser after testing and before putting the silicon in the protective packaging.
- p_j_w 6y agoFuses aren't blown with a laser, it's purely electrical. You apply a sufficiently high voltage to some port on the part from a source that can drive a high enough current and then tell the digital block of the chip which address to fuse and if you want it high or low. Repeat for the entire fuse bank and you're done. https://en.wikipedia.org/wiki/Efuse https://en.wikipedia.org/wiki/Efuse
- mechagodzilla 6y agoIt might actually use a traditional fuse block, where at some point in the packaging/testing process, you literally apply a sufficiently high voltage that you can permanently 'set' some part of it (whether that's actually melting a tiny wire, I'm not sure). But that's basically just programming a ROM that gets read in at boot time, and sets a bunch of logic on the chip to route around the bad parts. You could just use an external EEPROM to track that info too, and it would basically work the same.
- andrewf 6y ago20 years ago people were overclocking AMDs by drawing on them with pencil: http://www.ocmelbourne.com/tutorials/PencilTrick/ http://www.ocmelbourne.com/tutorials/PencilTrick/ This last decade people soldered resistors onto cheaper NVIDIA cards, to make them behave as more expensive NVIDIA cards: https://www.eevblog.com/forum/general-computing/hacking-nvidia-cards-into-their-professional-counterparts/?PHPSESSID=3kesesdcd2gp8tftrkiihn6ef2 https://www.eevblog.com/forum/general-computing/hacking-nvid... So chipmakers have an incentive to bury the process in the chip and make it irreversible.