6 ms·
Ish. Dryers can literally melt heavily-synthetic clothes. Been there, done that.
by toyg 6y ago
Ish. Dryers can literally melt heavily-synthetic clothes. Been there, done that.
- bluGill 6y agoTurn the temperature down. You shouldn't dry anything that hot, it just wastes energy.
- anamexis 6y agoI can certainly see other reasons to not run the dryer so hot, but why would it waste energy?
- BrianOnHN 6y agoThe hotter the coils the higher the amount of energy that's required to maintain it.
- anamexis 6y agoWell yes, but also the faster it dries your clothes and shuts off.
- BrianOnHN 6y agoYes, but it's not a simple linear use of energy. For example, it might use 10x energy to dry twice as fast. That's a gain if you're in a hurry, but not so much if you're relaxing at home, on a tight budget, and/or have unusually high cost of electricity.
- anamexis 6y agoIt might, but does it actually? Or does it use 2.05x energy to dry twice as fast, making the energy use difference negligible? Edit: Consider also that the shorter you run the dryer for, the shorter you are running the (substantial) motor and fan, as well as less time spent heating the shell of the dryer and the air surrounding it.
- BrianOnHN 6y agoIdk about the rest but the ratio of energy used by the heater compared to the motor is greater than 10:1. Edit: 20:1 mentioned here https://qr.ae/pGNTie https://qr.ae/pGNTie
- anamexis 6y agoIf we assume for just a moment that the time to dry clothes scales linearly with heat applied, we can try to run some numbers: Total power usage for full heat is (5000W + 250W) * 0.5h = 2625 Wh Total power usage for half heat is (2500W + 250W) * 1h = 2750 Wh So that's a 4.6% increase in efficiency for using full heat over half heat. So the big question remains, does lower heat dry clothes more efficiently, and if so, how much? The Stack Overflow answer you linked raises some interesting points, but doesn't seem rigorous.
- BrianOnHN 6y agoFrom an industry pdf I stumbled across, it looked like moisture sensing improvements were the best bet to save the most energy. Though, I didn't see anything about comparing heat settings in that doc, which may be telling.
- bluGill 6y agoDepends, for most dryers the temperature is limited because water evaporation is taking all the energy. The motor takes the same energy per time, so twice as fast actually uses less energy. However there is a limit to this, eventually (the end of the cycle) you reach the point where water isn't evaporating fast enough to use up all the input energy and temperatures go up to heating clothing fibers to no useful purpose and this is wasteful.
- adrianmonk 6y agoAlso, is the dryer located in a climate-controlled part of your home? If so, the air that it exhausts will be made up in equal volume by outdoor air pulled into your living space. How much extra energy does that make your heater or AC use?
- bkor 6y agoThat's not true though. The additional energy to create that heat doesn't have to equal the time saved. You'll notice this in heat pump dryers. They cannot generate the same amount of heat. They take way longer to dry the clothes. But they're way more energy efficient than other forms of dryers. Edit: I thought of another example. Heating your home with hot water running through radiators. It's significantly more energy efficient to reduce the temperature of the water. This outweighs the additional time it takes to heat up your home. There are various drawbacks and considerations though, e.g. if the house has terrible insulation (noticeable draft) then it'll not be beneficial. There's various other things that'll significantly reduce energy usage, this while anyone would assume that generating heat is already very efficient.
- contravariant 6y agoTo some extent drying clothes is generating heat (evaporation heat). If you're clever about it you might be able to avoid heating the (wet) clothes and rest of the contents of the dryer (or the outside!) too much. However evaporating water requires an incredible amount of energy, even if you just boil water away then most of the energy is still spent evaporating the water rather than heating the water, so it's not really too clear-cut that running a dryer hot is massively inefficient. Edit: Also it's not that using lower-temperature water to convey heat is somehow more efficient, the thing with heat pumps is that they are more efficient at heating things to a lower temperature. If you're burning gas it doesn't really matter either way, you just get the energy out you put in.
- BrianOnHN 6y agoSo would microwaves be the way to go? Edit: too much metal on clothing...
- peterburkimsher 6y agoUltrasound might work! https://www.energy.gov/eere/articles/no-heat-no-problem-ultrasonic-dryer-dries-clothes-half-time https://www.energy.gov/eere/articles/no-heat-no-problem-ultr...
- bluGill 6y agoBecause all you are doing is heating up clothing. Until near the end of the cycle your dryer is putting all the energy into evaporating water, so the temperature inside the dryer is actually fairly cool. Right at the end things change as the remaining water isn't enough to counteract all the energy being put in and so you heat the clothing to no purpose. So at the end off the cycle you should either shut off with a little moisture in the clothing, or regulate the temperature so that the heat input is balanced by the water evaporation.
- BrianOnHN 6y agoMy dryer seems to only have one setting, "hot af so be careful what you put in here."
- cryptonector 6y agoThat's a sign of a broken or stuck thermostat. You can replace it (or have it replaced). I lost a few shirts once because of that.
- adrianmonk 6y agoOr maybe a broken thermostat heater. Apparently this is a separate component sometimes. What on earth is thermostat heater, you ask? Surprisingly, many dryers apparently have a simple fixed-temperature thermostat, and in order to make lower settings work, a heating element tricks that thermostat into perceiving a higher temperature. If that heating element doesn't do its job, then the dryer acts like it's always on the highest setting. From https://applianceassistant.com/Dryer-Repair/How-Electric-Dryer-Parts-Work.php#thermostatHeater https://applianceassistant.com/Dryer-Repair/How-Electric-Dry... : > The thermostat heater is often located within the cycling thermostat. However, it may sometimes be a separate component mounted to the dryer's cycling thermostat. Depending on the dryer's temperature setting, more or less voltage is supplied to this heater. Low settings supply more voltage and create more heat, while medium settings supply slightly less voltage, generating less heat. High heat settings will not energize the thermostat heater at all. In this way the thermostat is tricked into thinking that the dryer is hotter than it actually is, so it opens at a lower drum temperature.
- cryptonector 6y agoTIL! Thanks!
- NullPrefix 6y agoCondescending tip - synthetics are for engine oils, not clothes ;)
- ambentzen 6y agoFor daily clothes, sure. For sports clothing, synthetics all the way. There is no worse pain in the world than sweaty chafing cotton.
- Aloha 6y agoI generally avoid any synthetic that is not a cotton blend, I want to be able to was on hot and dry on bake.
- peterburkimsher 6y agoSounds like we need ultrasonic no-heat clothes dryers to be commercialised. The technology is there - just play music to the water molecules, and they dance! https://www.energy.gov/eere/articles/no-heat-no-problem-ultrasonic-dryer-dries-clothes-half-time https://www.energy.gov/eere/articles/no-heat-no-problem-ultr...
- sdeframond 6y agoOr microwaves? (Better not leave anything metallic in there though...)
- bkor 6y agoThe article compares the energy savings over an already inefficient dryer. The article mentions that an existing dryer takes 50min (average). Such dryers are not what anyone should buy, they waste too much energy. Over time it's cheaper to buy a heat pump dryer. Those easily take 2.5 hours to dry. They're significantly cheaper over an e.g. 5-10 year period than buying a cheaper and way more inefficient dryer. The links to more detail with: > The goal of this project is to develop a clothes dryer prototype, using ultrasonic transducers, with an EF above 10 lb/kWh. But also: > DOE’s Building Technologies Office is seeking new clothes dryer technologies that can increase the energy factor (EF) from 3.7 to 5.43 lb/kWh However, a quick Google shows that the 3.7 is not a heat pump dryer, see e.g. https://www.intechopen.com/books/current-drying-processes/the-study-of-fabric-drying-using-direct-contact-ultrasonic-vibration https://www.intechopen.com/books/current-drying-processes/th.... The figure for an existing dryer should be 7.6 lb/kWh. Meaning, the solution is (currently) not good enough. The link in the article and my link shows that the intend is to go way over 10 lb/kWh. The link I found showed it could be around 20 or even 44 lb/kWh (seems to depend on the frequency used). This while being way quicker than anything else, especially heat pump dryers.
- scotty79 6y agoHey. If it melts it melts. Only survivors get to be worn.
- photojosh 6y agoWe have the same philosophy in the kitchen; we call it "dishwasher Darwinism" [0]. Unfortunately doesn't work quite as well with clothing. Or perhaps I could make an analogy that lingerie is like a good knife? [0] Stolen from somewhere online and can't be bothered to find the original source.
- photojosh 6y agoAha, "dryer darwinism" works for the alliteration too. Can't believe I didn't realise that until now.