3 ms·
So I just recalled I had a DC-capable clamp meter, and I was able to isolate the disk on the last stretch of a power connector chain. I tried running with both
by magicalhippo 6y ago
So I just recalled I had a DC-capable clamp meter, and I was able to isolate the disk on the last stretch of a power connector chain.
I tried running with both the power management set to "Level 128 - Minimum power usage without Standby (no spindown)" and Acoustics Managment to "Maximum", as well as "Disabled" for both. Didn't make a noticeable difference on power draw, at most 0.1A more during writes, primarily just noise.
Idle
5V 0.27A
12V 0.40A
Write
5V 0.53A
12V 0.50A
So that's just over 6W idle and 8.7W under load. I'm surprised about the high idle draw, both due to being significantly higher than the specs[1] and due to them running so cool. Did they spin down the disks to get the 4W figure perhaps? I did check my clamp meter against my electronic load and it reads pretty accurate.
I didn't manage to test reads properly, since the disks are part of a ZFS pool and it spreads the reads all over, along with aggressive caching.
[1]: https://toshiba.semicon-storage.com/us/storage/product/data-center-enterprise/cloud-scale-capacity/articles/mg07acaxxx.html https://toshiba.semicon-storage.com/us/storage/product/data-...
- bscphil 6y agoThanks for testing! That does seem kinda high. Western Digital has the following figures for 14 TB WD Reds: Read/Write – 6.2 W Idle – 3.0 W Standby and sleep - 0.8 W Which strikes me as pretty reasonable. I suppose I'll stick with those since I can rip them out of EasyStores.
- magicalhippo 6y agoToshiba datasheet says 8.1W under Q1 4k random R/W, I did my testing with streaming writes and queue depth around 10, so my write figure seems reasonable. For idle the datasheet says 4.53W typical, however I admit my disks were idle only for a few minutes when I did my readings as dinner was almost ready, so possible they would go lower after longer idle periods.