3 ms·
You can't get lower key-to-screen latency than an 8-bit computer on a CRT. Well, most of them. My Interact draws characters pixel by pixel.
by phkahler 6y ago
You can't get lower key-to-screen latency than an 8-bit computer on a CRT.
Well, most of them. My Interact draws characters pixel by pixel.
- ddingus 6y agoBitmap character displays were kind of neat back then. My Model 100 does the same.
- charcircuit 6y ago>You can't get lower key-to-screen latency than an 8-bit computer on a CRT. Why? My current monitor has a refresh rate of 144Hz and a response time of less than 1ms. This means that it will have lower latency than a CRT on average. I am sure you can produce a video signal on something other than an 8 bit computer.
- phkahler 6y agoBut there is a lot of software on your system. The only thing in your favor is the higher refresh rate. When the 8bit system gets a key press, it literally writes one byte to memory to put it on screen. A modern system will have to paint a glyph - which is super fast - but then may have to go through a compositor and possibly wait for V-sync. You're luck if the software stack doesnt introduce at least one frame of delay.
- ddingus 6y agoAnd that 8 bit computer could drive higher refresh rate devices and still be lower latency, or at the least, par. At this point, there are some really fun options for this kind of thing! This chip: https://www.parallax.com/propeller-2/ https://www.parallax.com/propeller-2/ is 32 bit, can run at a few hundred Mhz and has a very simple, retro feel, in that the 8 processors run wither either concurrently and independently, or can be used in parallel. The fun thing about all that is being able to build up fairly sophisticated applications or perform advanced control tasks without needing the complexity of a RTOS. In that low latency case, one core would be delivering a character or tile display, maybe with sprites, and once that is done, your programs can be simple, write that byte to screen type. Frame locked, low latency, single or partial buffered display schemes are all possible, even racing the beam style. Display support exists from old school monochrome 50 / 60hz composite through VGA and HDTV analog at 1080p, to reasonable HDMI. Racing the beam on an HDMI display is possible much like a CRT, depending on how the display buffers the bitstream. I like to treat these like new retro devices. Good fun and practical. (Have one device in the field using the simpler, original edition.)