3 ms·
I'd like to see #29 used in a 3d printer. One spiral driving 3 gears that pull the filament down through the center directly into the hot end. A tiny stepper sh
by phkahler 6y ago
I'd like to see #29 used in a 3d printer. One spiral driving 3 gears that pull the filament down through the center directly into the hot end. A tiny stepper should do since there is a huge mechanical advantage.
- sgtnoodle 6y agoHow would you tension the three gears to provide the right amount of pressure across variations in filament diameter? I wonder how much wear there would be in the spiral sliding across the gear teeth.
- phkahler 6y ago>> How would you tension the three gears to provide the right amount of pressure across variations in filament diameter? Good question. The teeth should be 1/3 apart, so maybe just dig in if the filament is too thick? There has to be a way, it's just too bougie not to exist.