4 ms·
Are these tests akin to speedtest.net for a few minutes, or iperf over wireguard for a few hours?
by mindslight 6y ago
Are these tests akin to speedtest.net for a few minutes, or iperf over wireguard for a few hours?
- sokoloff 6y agoThose are speedtest.net, but being careful to choose a test endpoint not under Comcast's control. I just did one again and got 323/11. https://www.speedtest.net/result/11034876082 https://www.speedtest.net/result/11034876082 Assuming the setup time on my end is reasonable, I'm happy to run other tests for the thread's benefit.
- mindslight 6y agoSpeedtest.net isn't a great a measurement because cable is notoriously bursty. Cable ISPs will give you the full (neighborhood) pipe for a minute, and then throttle you back to some set speed. This is helpful to speed up web browsing, but not when measuring bandwidth. I'd recommend timing any big upload that takes at least an hour. Ideally encrypted and somewhat unique, so that it's not likely to be prioritized or served by an edge box.
- sokoloff 6y agoI wasn't willing to go for an hour, but I planned an upload of one that would take about 15 minutes (to get well past any initial burst rate). The upload rate started at 1.3 MiB/s, quickly climbed to 1.4 MiB/s and stayed there the entire upload. This is a shot on my personal iPhone family video, so there's zero chance that it is cached anywhere. If you compute using a file byte as being 8 network bits (the reality is slightly higher, of course), you get: jsokoloff@Jim-Macbook Downloads % time aws s3 cp iPhone_opening.MOV s3://XXX-XXX/photos/ upload: ./iPhone_opening.MOV to s3://XXX-XXX/photos/iPhone_opening.MOV aws s3 cp iPhone_opening.MOV s3://XXX-XXX/photos/ 12.84s user 7.66s system 2% cpu 14:38.47 total jsokoloff@Jim-Macbook Downloads % ls -la iPhone_opening.MOV -rw-r--r--@ 1 jsokoloff access_bpf 1265329653 Aug 22 2020 iPhone_opening.MOV jsokoloff@Jim-Macbook Downloads % echo -ne "bps: " && echo "1265329653 * 8 / (14 * 60 + 38.47)" | bc bps: 11523031 jsokoloff@Jim-Macbook Downloads % echo -ne "Mibps/100: " && echo "1265329653 * 8 / (14 * 60 + 38.47) * 100 / 2 ^ 20" | bc Mibps/100: 1098 So, 10.98 Mibps (11.52 Mbps) for an almost 15 minute period, which matches the above extremely closely.
- mindslight 6y agoThat's a much better test and thanks for doing it. I usually use a factor of ~10 (9.5) to go from advertised Mb/s to actual MB/s, so I agree 1.4MB/s is decently better than the 10Mbps quoted. Of course the ultimate test is hopping on a popular torrent ;)