39 ms·
Genuine protip: Replacing through-hole parts on motherboards is exceptionally difficult. There's so much copper in a modern multilayer board that it's very dif
by jdietrich 15y ago
Genuine protip:
Replacing through-hole parts on motherboards is exceptionally difficult. There's so much copper in a modern multilayer board that it's very difficult to get enough heat in without cooking something delicate. Even with preheat, a reflow gun and a powerful iron it can be very hard going.
Replacing broken PSU connectors is one of the most common laptop repairs and should be an easy job, but has a dismally low success rate.
- swishercutter 15y agoIf you are replacing the connector and you don't care about reuse I find it is best to cut off the part then just do cleanup, remove as much as you can to eliminate the heatsinking. Then its up to tip size, temperature and flux...even still I can't say I have not lifted a few pads in my day.
- chopsueyar 15y agoDo you use a de-soldering iron?