3 ms·
Just imagine how much you could get with a wire.
by jeffbee 6y ago
Just imagine how much you could get with a wire.
- cbhl 6y agoGetting a wired connection above 1 Gbps seems non-trivial -- there are products that do 2.5 Gbps, and other products that do 10 Gbps. It seems like you'd have to pick one or the other and hope the rest of the world standardizes on the same speed as you.
- zymhan 6y ago10GbE is a standard. It's expensive for home users, but it's very much the standard for faster-than-gigabit ethernet. https://en.wikipedia.org/wiki/10_Gigabit_Ethernet https://en.wikipedia.org/wiki/10_Gigabit_Ethernet
- amarshall 6y ago> there are products that do 2.5 Gbps, and other products that do 10 Gbps And 5, 25, 40, 50, 100, 200, 400 Gbps. > seems like you'd have to pick one or the other and hope the rest of the world standardizes on the same speed as you Huh? A connection between A & B will just be as fast as the slowest link between them, be it 400 Gbps or 6 Mbps, regardless of the various other speeds. And a 10GBASE-T NIC will happily autonegotiate with a 10BASE-T NIC and everything in-between.
- jeffbee 6y agoNot that I imagine it causes problems in practice, but as a point of order I think 10G copper PHYs cannot negotiate below 100BASE-TX.
- amarshall 6y agoMaybe, not sure. I can’t immediately find anything that would specify as such, but I suppose adapters could opt to not support some modes (and I guess technically I may have been overreaching a bit on that bit anyway since autonegotiation is only mandatory at all in 1000BASE-T and later).
- pantalaimon 6y agosome 10G-BASE-T cards don't support the 2.5G and 5G modes as those got standardized later.
- flemhans 6y agoSome even don't support 100 Mbit. But most do. :D
- deleted 6y ago[deleted]
- GloriousKoji 6y agoI imagine around 2.5Gbps as that seems to be the speeds the compute module is getting using a SATA RAID. If we want to be optimistic then it would be 5Gbps as that's the limit of PCIe on the Pi.
- geerlingguy 6y agoReal-world usage it seems like somewhere around 3.5-4 Gbps is the limit on the PCIe x1 lane on the Pi—I'm still doing more testing around that. I'm actually testing a 2.5 Gbps card with the Realtek RTL8125B chip in it now: https://github.com/geerlingguy/raspberry-pi-pcie-devices/issues/40 https://github.com/geerlingguy/raspberry-pi-pcie-devices/iss...
- FooHentai 6y agoOptical maybe, but copper has more limitations. Signal propogation in air is faster, and with things like beam-forming there's big advantages to having multiple sending and receiving points spread apart. So to push speeds in a similar way with a wire you might end up needing a mesh of wires. Power delivery and (relative) protection against signal degredation are, for me at least, the remaining big reasons to wire things in. Speed not so much.