4 ms·
I'm not sure it was possible, the cables were likely anchored (frayed then sunk in concrete), it would have required setting up a mobile anchor, cutting the cab
by masklinn 6y ago
I'm not sure it was possible, the cables were likely anchored (frayed then sunk in concrete), it would have required setting up a mobile anchor, cutting the cable from the anchor, adding lengths of cables somehow, and unspooling those extra lengths. It's already not done for suspension bridges[0], I don't think it could be done here.
And the risk would obviously have been gigantic as two cables had already snapped in the same place, so the remaining cables would be under insane and completely out of spec tensions, meaning they could fail at any point during the tentative transfer work.
[0] you either splay open the main cables and replace strands, or you need to jack the entire bridge from below to take down and replace the main cables at once
- robocat 6y agoQuick google: Presently, cable replacement designs are being developed for three suspension bridges in the United States. All three are important river crossings at or near a major metropolitan area and must remain open to traffic during construction. These cable replacement designs will need to overcome myriad difficulties, including cable support at the existing tower tops and placement of new anchorages within restricted available spaces. Alternatives will include placing the new cables above or adjacent to the existing ones. The construction procedures and load transfer sequencing is a critical part of the design. The new cables will need to be erected in their free position and will undergo substantial deformations as the load is transferred to them. Additionally, the existing cables and towers will undergo their own deformations, as will the bridge superstructure as it is released from the old and supported by the new suspension system. The work will require extensible hangers to accomplish the load transfer, and all operations must be coordinated to limit changes in the roadway geometry and stresses in the superstructure, towers and suspension components.