4 ms·
Understanding LCD Monitor Color Gamuts
- bradknowles 6y agoFrom 2011. Lots of things have changed since then.
- bleepblorp 6y agoMost notably that manufacturers now use very narrow gamut LCD panels (50% NTSC, or even 50% sRGB) in low/mid range screens to force consumers to spend vastly more on hardware than was necessary, even a few years ago, to have access to devices with reasonable color rendition. Charging the same prices for items of inferior quality is one way capitalism can increase inflation without it appearing in the official statistics.
- Jonnax 6y agoHow cheap are you talking about? Because from what I've seen that's not the case. Most monitors hit sRGB. Easily. Unless you're talking sub $100. The differentiating factors today are high refresh rate or HDR where the DCI-P3 gamut is the gamut to hit. sRGB is almost like expecting a car to have electric windows. There's a HDR certification for displays where HDR 1000 is actually real HDR. https://displayhdr.org/ https://displayhdr.org/
- Kye 6y agoThey probably mean laptop screens. Finding one with full sRGB is very difficult.
- zamadatix 6y agoMost notably HDR standards which (usually) specify a newer wide gamut not covered in the article and a wider luminosity range that has to be thought about separately. Cheap displays in cheap devices has always been a thing, particularly for LCD panels over the years. If anything I've seen cheap LCDs tend to get better over time not worse but that's just an anecdote.
- ScottBurson 6y agoPeople with strong eyeglasses (more than 3 or 4 diopters positive or negative) may find wide-gamut monitors hard to use for text. The problem is that chromatic aberration is wavelength-dependent; the larger the difference in wavelength between two photons, the greater the angle between the paths they take when they pass through the lens. (Except at its optical center, the surfaces of the lens aren't parallel, so there's a prism effect, which increases toward the edge of the lens.) These wide-gamut monitors have both a deeper red source (longer wavelength) and a deeper green (shorter). So the red and green peaks are quite a bit farther apart -- possibly as much as 80% -- than they are with a standard CCFL or WLED backlight. Combine that with high-index plastic lenses, which have higher dispersion (a measure of chromatic aberration) the higher their refractive index, and you can get a real problem. Since my correction is about -6.75 diopters, and I have wide-gamut monitors, I had a pair of glasses made with CR-39, a relatively low-index plastic with low dispersion, almost as low as that of glass. CR-39 is generally not used for such strong lenses because they would need to be thick at the edges, but this problem can be minimized by making the lens round in shape and not too large.
- SomeHacker44 6y agoVery true. I have a touch less than 3 diopters of astigmatism, and have difficulty with chromatic aberation already, especially with pictures made only of red and blue (such as some micrographs with various fluorescents). RGB led indicators also get resolved into a red and adjacent blue dot with some frequency (no pun intended). It is worse since aging, presbyopia, and switching to progressive lenses, even with only 1.25 to 1.75 of near vision correction.