2 ms·
There's a pretty simple solution to the power problem: You can measure the flow of steam in the system by dropping two tanks in series in the pipe and finding
by jcranmer 6y ago
There's a pretty simple solution to the power problem:
You can measure the flow of steam in the system by dropping two tanks in series in the pipe and finding their difference in level--the difference is proportional to the amount of steam being consumed. After some experimentation in creative mode, I found the difference level that corresponds to the need to enable another reactor. Then I set up the inserters to each plant to only take in new fuel cells when the steam draw exceeds the relevant threshold.
This does have some waste in that it doesn't count for hysteresis, and it doesn't try to prevent the reactors from filling up, but at the level of megabase I had, that level of waste wasn't an issue for me.
- AgentME 6y agoI set up my steam turbines to only turn on if an accumulator fell below 20% and then stay on until the accumulator is above 90%. Then I set up my nuclear plants to only be fueled if they're not currently fueled and my steam supply is under a certain level and then stay on until it's above a certain amount.
- AceJohnny2 6y ago> and then stay on until [steam is] above a certain amount. I presume that certain amount leaves enough headroom for steam generated by a full fuel cell cycle (ie worst case scenario) ?
- AgentME 6y agoRight, usually the plant keeps running for a while after I decide to stop putting fuel in, and I don't want it to ever be running while my steam tanks are all full because that would be a waste.