3 ms·
Great tool, super useful. For a few extra bucks you can use a programmable temperature controller... search "Programmable Temperature Controller Ramp Soak Heat
by rfrey 6y ago
Great tool, super useful.
For a few extra bucks you can use a programmable temperature controller... search "Programmable Temperature Controller Ramp Soak Heat" at the usual suspects. Allows you to program heating ramp up, ramp down, and soak times - very useful for heat treating various alloys.
- vvanders 6y agoYup, Automation Direct is my go-to "cheap" option for this. They also make some very low cost PLCs that work pretty well. I built a solar powered DC irrigation pump with proper PID control+SSR to support varying flow rates(most irrigation pumps are on/off only) with their hardware.
- dkdk8283 6y agoI used an off the shelf controller for my pump. About $100 for a 3A VFD not including transducer
- vvanders 6y agoYeah, most pumps are AC and this was DC so I didn't have a off the shelf solution. With a PLC, analog input for the pressure sensor and SSR to drive the PWM it was fairly straightforward to put together. Hardest part was getting the PID tuning right but even that only took a bit of time.
- dkdk8283 6y agoWhat PLC did you use? I’m looking to build a load shed controller for another project. I’ve been looking for something simple.