4 ms·
As a DIY'er SMDs are a massive pain as they are hard to impossible to solder and need special PCBs, which I think is what DoingIsLearning is getting at. Holes
by mytailorisrich 6y ago
As a DIY'er SMDs are a massive pain as they are hard to impossible to solder and need special PCBs, which I think is what DoingIsLearning is getting at.
Holes are already drilled in your veroboard, that's what they are for, your job is to solder and you want it to be easy and simple.
- sokoloff 6y agoSMDs with leads and 0603 or larger are quite easy to solder in my experience, at least on a factory-made PCB with solder mask. I can hand assemble SMD faster than thorough-hole, using a temp-controlled iron for both. (I have hot air rework station as well, but most of my SMD assembly is with a fairly inexpensive iron.) SMD is a pain during prototyping and experimenting because they’re harder to use on breadboards (breakout boards are an additional step and possible point of failure). After the breadboarding stage, I think SMD is easier and faster.
- kps 6y ago> in my experience In your experience. I solder under a stereo microscope, but I don't go smaller than 1206.
- foldr 6y agoEveryone's different, but my experience tallies with sokoloff's. With the right technique it's no problem to solder 0603 with the naked eye. 0402 is possible but very fiddly. 0201 is really pushing it. A microscope is a useful aid, especially if you're longsighted.
- foldr 6y agoIt's really not difficult to solder SMD components. See e.g. https://www.youtube.com/watch?v=b9FC9fAlfQE&t=1518s https://www.youtube.com/watch?v=b9FC9fAlfQE&t=1518s for a good introduction to the relevant techniques.
- JAlexoid 6y agoIt's not impossible. But it is not as easy as through hole
- rcxdude 6y agoIt really is. That's kind of my point. When I was starting I spent a lot of time and effort to make a design with all through-hole components because I perceived that surface mount was difficult. The design suffered massively from that compromise, it was still a pain to assemble, and when I actually tried surface mount later I felt completely cheated. Soldering a large pitch SMD micro is actually quicker and easier than soldering a DIP, even with crap equipment (though it's always more difficult with crap equipment).