3 ms·
You're describing the Part workflow. In Part Design you would move the hole by opening the sketch that defines the circle and changing the position of the circ
by jstanley 6y ago
You're describing the Part workflow.
In Part Design you would move the hole by opening the sketch that defines the circle and changing the position of the circle.
- polack 6y agoYes, this is how I usually do it and it's not uncommon that it becomes an issue when moving the circle. To be fair there is usually a fillet or something connected to the hole, but I still don't see why that should be a problem.
- jstanley 6y agoMoving the circle doesn't usually present a problem. Adding new circles presents a problem because then you get different internal names for the edges and the fillet gets attached to the wrong place. Moving the circle can create a problem if, for example, you specified a 5mm fillet but now the circle is only 3mm from the edge and therefore the fillet doesn't fit.