3 ms·
there is a tool for rectangular waveguides as well. http://www.wikarekare.org/Antenna/Waveguide.html http://www.wikarekare.org/Antenna/Waveguide.html one of t
by rolph 6y ago
there is a tool for rectangular waveguides as well.
http://www.wikarekare.org/Antenna/Waveguide.html http://www.wikarekare.org/Antenna/Waveguide.html
one of the things you get with these antenna styles would be lobing. there is usually four side lobes, at quarter wave peaks a diminished rear lobe and the front lobe business end. wifi dongles with removable antennas are not so common nowadays but you can install an SMA connector if you have steady hands and a fine solder iron, just remove one from an old router.
there is also the usage of the whole router with custom firmware configured as a repeater or an extender with custom antennae
yes things are made hard ...for most people but thats when the hat goes on head and hard == fun, challenging
and yes you want to mind the power you put into these things and what you point it at. my first cantenna also had a rifle scope, webcam, and a laser pointer in a tidy little gang. i never got around to stacking it on a PTZ camera but theres still time for fun in my schedule
[edit adm] The connectors are not so problematic if you have stuff sitting around you and are not shy of modifying the feed connection, i run sma coax soldered to the routers board on one end and 50 0hm connection on the other end. the connector is only convenience any way you can solder the coax end in place at the waveguide and you will actually get rid of signal loss due to the connector impedance. it also helps to keep the coax length short but avoid multiples of the signal wavelength or you will get reflection in the wire.