3 ms·
Edit: I forgot about inexpensive arduino nano boards. I'll leave my original incorrect comment below though. Is this supposed to be geared towards hobbyist? If
by ineedasername 6y ago
Edit: I forgot about inexpensive arduino nano boards. I'll leave my original incorrect comment below though.
Is this supposed to be geared towards hobbyist? If so, the $1 cost is sort of irrelevant if you have to spend $20 to $100 on programmers, development board, etc., when you can get a Pi Zero for & micro sd card for about $10 and be up & coding in an hour.
- thisgoodlife 6y agoNo, you don't need $20 programmers. I played with attiny85 microcontrollers in my pet projects. A $2 Arduino Nano is all it takes to program the chip.
- ineedasername 6y agoAh, that's right! I should have remembered, I have about 5 of them in my home shop setup.
- sgt 6y agoArduino Nano seems to be closer to $20 rather than $2. Where did you get that figure from?
- krallja 6y agoArduino is open-source. AliExpress has clones for under $2.
- sgt 6y agoFor just one unit I will just buy the original, I think, and support the project.
- snvzz 6y agoIf you really want to overpay for what's basically a commodity these days, to support a project that was already wildly successful a decade ago and has outside growth several times the size of the original project... go ahead.
- danellis 6y agoYou can also get a Nucleo board from ST Micro for about $10. It has a built-in programmer.
- deleted 6y ago[deleted]
- jpindar 6y agoAnd if you use your desktop computer, you can be up and coding in a few seconds. But as with the Pi, you won't be working with bare metal microcontrollers which are the point of the article.