4 ms·
There's no mention of using desoldering braid (or even the suction bulbs) to fix bad joints? Sorry, but I don't like the "whack the circuit board on the table"
by Natsu 16y ago
There's no mention of using desoldering braid (or even the suction bulbs) to fix bad joints? Sorry, but I don't like the "whack the circuit board on the table" method.
Once you get used to doing it right, desoldering braid is awesome. I never did get the hang of those squeeze bulbs, though. The braid was always so much easier to use.
- calloc 16y agoI've found that sometimes both works. Especially for through holes, the de-solder braid may not get in deep enough on the PCB hole to suck up all of the solder, and repeatedly heating up the same area on a PCB is a bad idea. Heat it up, swift downward motion (slamming your fist on the table holding the PCB between your finger and your thumb) and the solder will come flying right out.
- Symmetry 16y agoThey're keeping it simple. No mention of microscopes, dental tools, hot air guns, flux pens, or solder paste either. But yeah, I'm not sure I'd try his desoldering method either.
- Natsu 16y agoI wouldn't complain if they didn't mention desoldering at all. But they do mention it and they only give one method for it, as if that's the only way to do it! I've actually done more desoldering than soldering and I would have gone crazy if I had tried to do it that way. I find braid to be the easiest method by far, but that's just personal preference. I'm sure there are people other than me who can get the suction devices to work well and who don't have to buy braid all the time.
- gamble 16y agoYeah, I cringed at that part too. The trick with desoldering is that sometimes you need to add more solder before you can remove it. If a joint won't desolder, the easiest solution is to add a bit more solder until it balls up, then suck it all away with a spring-loaded solder pump. I find desoldering braid a bit tricker, but the secret there is to prime the braid with a bit of solder to improve heat transfer before holding it to the joint.