4 ms·
Is there a way to know how my monitor does this?
by taeric 6y ago
Is there a way to know how my monitor does this?
- EricE 6y agoI'd like to know this too!
- PascLeRasc 6y agoI've been reading that NAND flash doesn't support erasing individual bytes, while EEPROM does. If there's some way to attempt this and know the outcome, maybe that's a way to figure it out.
- GekkePrutser 6y agoThe problem is that eeproms don't do wear leveling. Not internally and they're usually controlled by a simpler microcontroller that doesn't have enough resources to do it in software. So every time you write to three same byte you're writing the same cell. 100.000 cycles is actually much more than current flash generations.
- Polylactic_acid 6y agoThese days basically every kind of mass storage device you will use has its own dedicated controller chip which is pretty much a cpu with its own RTOS now. Those 2 cent 8kb eeprom ICs don't but its crazy how complex something like an sd card is.
- simcop2387 6y agoSome of those SD cards run linux! https://hackaday.com/2016/06/30/transcend-wifi-sd-card-is-a-tiny-linux-server/ https://hackaday.com/2016/06/30/transcend-wifi-sd-card-is-a-...
- arghwhat 6y agoNAND Flash is just a type of EEPROM. Early EEPROM could only be wiped entirely (but as this was done electrically, it was still an improvement over UV-erased EPROM), while EEPROM at the time of Flash's creation could often be byte-erased (as is the case now). Nowadays "EEPROM" mostly refers to small, slow, rarely written config storage for microcontrollers. As thus, they are also usually accompanied by low write/erase endurance despite their byte-erase granularity. Flash was meant as a higher capacity/performance version indeed sporting full block erasure as a downside, but nowadays it has supplanted EEPROM in all categories but small micro-controller usages. Plus, as capacity is now cheap, high write loads can easily be supported with write levelling (that is, writing to new locations instead of erasing/writing the same block over an over.)
- arghwhat 6y agoEither disassemble your monitor and lookup the ICs, find someone who already did it, or try to write about 100 000 times and see what happens... :)
- taeric 6y agoFair. I was hoping there was a list of common or known monitors that do this.
- barkingcat 6y agoYou could pay to buy monitors for people and ask them to toggle the brightness until it dies, then record it down on a wiki and opensource this information.
- coldtea 6y agoOr there could just be some part numbers that indicate a monitor has this issue
- neal_jones 6y agoYea, I'd really prefer to not brick two expensive monitors because of this. This thread has bummed me out.