3 ms·
The issue with using them in power supplies is the ESR (equivalent series resistance). Check out this Rohm data sheet for more info [1]. Aluminum polymer elect
by arcticbull 6y ago
The issue with using them in power supplies is the ESR (equivalent series resistance). Check out this Rohm data sheet for more info [1].
Aluminum polymer electrolytics already provide both large bulk capacitance and good ESR and ESL performance (although they’re a bit more expensive than more common chemistries).
Not to mention, you can reduce the capacitance necessary for your design by increasing the switching frequency so bulk capacitance isn’t nearly as important. You can also synthesize bulk capacitors with good ESR and ESL by using an aluminum electrolytic in parallel with, for instance, an MLCC ceramic capacitor or even niobium or tantalum. [2] Careful with tantalum though, not only is it a conflict material it tends to exhibit, uh, thermal runaway (they explode).
I didn’t see ESR performance in the write up but I suspect if it was low-ESR they would have led with that. Likely the 0.5mA/cm^2 limit is due to a sky-high ESR.
[1] http://rohmfs.rohm.com/en/products/databook/applinote/ic/power/switching_regulator/capacitor_calculation_appli-e.pdf http://rohmfs.rohm.com/en/products/databook/applinote/ic/pow...
[2] https://www.ti.com/lit/an/slyt639/slyt639.pdf https://www.ti.com/lit/an/slyt639/slyt639.pdf