If done right it is routine. In our small data centre we have a board with five lights and a key. You turn the key and the mains is cut off. The lights give

If done right it is routine. In our small data centre we have a board with five lights and a key. You turn the key and the mains is cut off. The lights give the status. The UPSs beep for a few seconds "on battery", the genny fires up in the boiler room and when it stabilises, it takes the load. We leave it running for 5-15 minutes, go out and check the fuel levels and top up accordingly. It's diesel so safe to hot refuel. When done, turn the key back and then the UPSs take the load again and then hand back to the mains. The genny runs for another 15 minutes and then shuts down. That should avoid flip flopping. You then fill in the test form on our wiki and job done. We do it weekly to fortnightly. An ESP8266 based thingie reports status back to the central monitoring (GPIOs and ESPHome -> Home Assistant)