5 ms·
I need 5v but I don't think any of the few FPGA chips that support 5v are actually usable with the Symbiflow stack. I do wonder what's the best way to translat
by snvzz 6y ago
I need 5v but I don't think any of the few FPGA chips that support 5v are actually usable with the Symbiflow stack.
I do wonder what's the best way to translate to 5v and back. There has to be some fast-switching, go-to part for the purpose.
- tyingq 6y agoUnfortunately, there's not a good single solution. Best depends on single vs bi-directional (also, which direction), switching speed, tristate or not, etc.
- snvzz 6y agoI do pretty much need to interface a 68000 bus. D lines and some signals need to be bidirectional. And I might even need to do bus mastering, so most signals would have to be.
- tyingq 6y agoThis doc might be useful: http://marc.retronik.fr/motorola/68K/68000/The_68000_and_its_interface_A.CLEMENTS_1984_14p%5D.pdf http://marc.retronik.fr/motorola/68K/68000/The_68000_and_its... And, yeah...you have some work ahead. Lots of bi-directional, tristate, open drain, totem pole/push-pull, etc.
- snvzz 6y agoYes, a major pita. Mainly afraid of not groking the bus and driving the bus at the same time as the 68k. The working idea is to use a bunch of some sort of voltage translator chip (finding the right one for this is the pain point), and imposing constraints so that if the CPU is driving the address or data bus as signaled by e.g. /AS or the R/W signal, then the translators won't drive it. With a bunch of 74s or a CPLD in the 5v side. I didn't have that one PDF, so I saved it for safe-keeping with my other 68k stuff. Thanks.