4 ms·
So far my chips are all sensors powered off USB. Adding relays is next level and I haven't done that. I've relied on smart plugs that are wall-wart style. Howe
by lostlogin 6y ago
So far my chips are all sensors powered off USB. Adding relays is next level and I haven't done that.
I've relied on smart plugs that are wall-wart style.
However I want to refill the boiler automatically on an old La Cimbali Junior and when I find an ultrasound sensor that will penetrate my espresso machine's boiler and detect a low water level (risking element burn out) I likely will though. I've tried a Hall sensor and one ultrasound sensor and neither work. I think I need an ultrasound sensor designed for fuel tanks or similar.
- Mister_Snuggles 6y agoA quick look at the manual suggests that there's a light that tells you when it needs to be filled with water. It might be easier to just trace that back and piggy back off of whatever sensor it already has. It may be too small for an ultrasonic sensor to work well. The ultrasonic sensors I've used are all basically blind to anything closer than 5-10cm.
- lostlogin 6y agoThis is a really good suggestion - my trust in that light is currently zero as I can’t get it to trigger reliably. Solving that issue is a rather more obvious way forward. Wood, trees etc.
- Mister_Snuggles 6y agoIf your goal is just to fill the reservoir automatically from a plumbed-in water source, without monitoring/logging water levels, a small float valve like this[0] might be a good answer too. I don't know how big the reservoir in your machine is, nor do I know if this particular valve is food-safe. You should definitely fix that light though. That sensor may also be part of a safety cutoff to prevent burning out the element. [0] https://www.amazon.ca/Kerick-Valve-MA252-Float-Adjustable/dp/B0077RAX4W https://www.amazon.ca/Kerick-Valve-MA252-Float-Adjustable/dp... This was from a quick search, I know nothing about this particular valve.
- lostlogin 6y agoThanks. I’m going to get that light fixed and I think it is the best way of monitoring the water level. The hard part with checking the water level is that the boiler is pressurised and very hot, which is going to be hard in any sensor.
- jon-wood 6y agoYou probably don’t need an ultrasound sensor or anything fancy for detecting water levels. Get a couple of strips of conductive metal which isn’t going to rust, then stick them down either side of the water tank, and finally hook the top of those strips into an ESP8266 or similar. When water level is above the required point the water will complete the circuit, and when it drops below the circuit will be broken.
- TeMPOraL 6y agoWill it do so even after going through whatever filtering scheme you're using? I was under the impression that clean water is a bad conductor.
- jon-wood 6y agoI had no idea about that, but some cursory Googling seems to indicate this property is only really true of fully purified water - either via distillation or turning it into steam first. I suspect that all but the most impressive water filters are still going to give you conductive water, but regardless it’s an easy thing to test.
- lostlogin 6y agoThanks for the idea. There are two water levels that could be monitored, the stainless reservoir and the brass boiler. Despite the metal I think it would still work for the reservoir, because this seems to be how new models work. It’s the boiler I mainly want to monitor however, and it is very hot and is pressurised.