3 ms·
Could you do it photographically? If you can photograph the head movements at a high enough frame rate, you should be able to calculate the acceleration that pr
by tzs 6y ago
Could you do it photographically? If you can photograph the head movements at a high enough frame rate, you should be able to calculate the acceleration that produced those movements.
- simonh 6y agoIt's about pressure and load, not movement. Also the sleds vibrate and shake enormously. Any method of measuring this has to be extremely precise, and also extremely responsive to changes over extremely short time frames to capture every vibration and shake in many different axes of freedom simultaneously. Before modern motion sensors I just don't think there was any way to do it. Even if motion was enough, which I'm sure it isn't, film only captures a flat image from a fixed point, or the camera is moving itself so you have to compensate for that. Springs and wires suggested by others have way too much hysteresis to cope with the extremely rapid vibrations and changes in orientation.
- yk 6y agoWhen you are looking for something like 80g (as is the maximum of the graph), then the head would move something like 4 cm between two frames, which suggests to me, that you probably want to have a lot more than 100 fps, since you want to get a good handle on the highest accelerations. On the other end of the scale, the positional error from the camera sensor is something like width of frame / horizontal resolution which should give you something in the mm range, and it seems possible to get head tracking in the same order of resolution, which should limit your acceleration measurement for low acceleration. Overall, probably doable but you are replacing a 30c accelerometer with a multi year research project.