3 ms·
Many variants on brick have been tried. Making bricks with tighter dimensional tolerances so they can be epoxied tightly together rather than using mortar is on
by Animats 6y ago
Many variants on brick have been tried. Making bricks with tighter dimensional tolerances so they can be epoxied tightly together rather than using mortar is one approach. The mortar is usually the weak point. But it didn't "look like brick". There are cement bricks, and, of course, cinder blocks. There are "poured stone" blocks, mostly for decorative walkways. There are rammed earth blocks. There are bricks in nonstandard shapes.
Bricks are reused all the time, mostly in places with old brick buildings and an underclass of cheap labor to chip off the mortar. Like Chicago.
The "let's just dump random construction debris in" approach seems kind of iffy. Figuring out how to make something from broken concrete might be more useful. If you want some broken concrete, and are in Silicon Valley, there's a plant on Seaport Boulevard in Redwood City that gives it away. They charge to dispose of concrete, break it into small pieces, and give it away as "base rock". From the size of the pile they have, even giving it away is tough.
- lostapathy 6y agoApparently in the trade "Cinder blocks" are referred to as CMU's (concrete masonry units). Just an FYI for anyone who wants to do more research.
- Animats 6y agoYes, with the decline of coal as a fuel, the supply of cinders is much diminished. Also fly ash, which is what the electrostatic precipitators at coal fired power plants pull out of the exhaust gases. Fly ash can be used in place of sand in cement.
- ehnto 6y agoRammed earth is my favorite conceptually, especially if your property has the source raw materials on the property. You're not externalizing the impact of your build, and it deteriorates right back where it came from.
- deleted 6y ago[deleted]
- hinkley 6y agoOne of the secrets of making predictable handmade pottery is to grind up old pots and mix the powder into the clay. Since it’s already fired, it is size stable, which increases the stability of the material. I don’t see why you couldn’t do the same with any other other wet materials, assuming you can fuse the new and old material properly.
- AstralStorm 6y agoTypical hack is the use of silicate (sand lime) bricks then just covering it with a thin veneer of standard brick for the look. Works well. These are bonded with poured concrete not mortar if they have the vertical holes, and much less than baked clay brick. Rather good material. The K-brick here seems redundant. Might be a slight improvement, perhaps, though lime is useful for its CO2 and NO capture.